Dear Bruce,
We've several high performance servers in the data center that each of
their bandwidth usage reachs about 300mbps. Our DataCenter connection to our
users is several Gigbit Ethernet Links and we've no management on users
network. So we've two place to setup our TAPs: the first place is near servers
with about 300mbps and the other place is our connection to users network with
about 400-500mbps each. On both of these places, a single IDS sensor can not
handle the traffic so I need a Load Balancer like appliance that can balance
the traffic to IDS sensors farm.
Please note that I want to analyze all of the traffic and no filter can be
applied on these traffics.
Thanks
"Briggs, Bruce" <Bruce.Briggs@suny.edu> wrote: It would be helpful for you
to tell us what you mean by a high traffic rate.
Is it possible to have multiple Snort sensors at lower traffic rate locations
in your network and still cover all traffic flows that you desire to monitor?
Bruce
---------------------------------
From: snort-users-admin@lists.sourceforge.net
[mailto:snort-users-admin@lists.sourceforge.net] On Behalf Of Angel R
Sent: Sunday, February 26, 2006 7:35 AM
To: snort-users@lists.sourceforge.net
Subject: [Snort-users] IDS Load Balancer
Dear All,
I'm going to start a project to implement an end to end IDS solution in a
data center. My problem is that high traffic rate in the data center leads me
to use an load balancer to balance the traffic to multiple Snort servers. I'll
be thankful if you help me to find a proper [including commercial] solution.
Thanks all
---------------------------------
Yahoo! Mail
Bring photos to life! New PhotoMail makes sharing a breeze.
---------------------------------
Yahoo! Mail
Use Photomail to share photos without annoying attachments.
