Re: Failover internet connections, and implementation...

You should also be able to setup the second connection and use both at 
the same time. Then If either of them is having a problem the traffic 
will use the other one. Look into a device capable of load balancing two 
connections. Then you are not "wasting" any equipment as it is actually 
being used to increase your bandwidth.

Larry Offley
www.offley.ca

Dan Denton wrote:
> I've a question about failover internet connections. I'm interesting in
> knowing what kind of implementations that other SMB's use for redundancy,
> and to switch to in the case of a DOS attack. 
>
> Do any of you have redundant highspeed internet connections for your offices
> (versus those for datacenters)? If so, what kind of setup do you have?
>
> Here's the setups I'm considering...
>
> 1. Have a second cable modem/dsl modem active, but not hooked into the
> network. In the event of a failure, move the connection for perimeter
> devices over to the standby connection and reconfigure the perimeter device
> to use a different IP.
>
> 2. Have a second set of perimeter devices (firewalls) programmed to use the
> IP's on the second connection, as a hot standby.
>
> My problem with the first option is the time it would take to reconfigure
> firewalls and IDS' to use the other ISP's connection. The problem I have
> with the second is the expense of firewalls and IDS' just sitting there
> idle. 
>
> Any input is greatly appreciated!
>
>
> Dan 
>
>
>
>
>