Re: Failover internet connections, and implementation...

I have yet to see a SMB use redundant ISP links.  However...

With a Cisco ASA 5505 you could have redundant ISP links for not that 
much money.

An SLA will monitor the health of the primary link, and in case it goes 
down, will automatically switch to the other link.  It can even be a 
different interface with a different public IP address.  The default 
gateway to the internet will be automatically populated in the routing 
table.

Anthony



Dan Denton wrote:
> I've a question about failover internet connections. I'm interesting in
> knowing what kind of implementations that other SMB's use for redundancy,
> and to switch to in the case of a DOS attack. 
>
> Do any of you have redundant highspeed internet connections for your offices
> (versus those for datacenters)? If so, what kind of setup do you have?
>
> Here's the setups I'm considering...
>
> 1. Have a second cable modem/dsl modem active, but not hooked into the
> network. In the event of a failure, move the connection for perimeter
> devices over to the standby connection and reconfigure the perimeter device
> to use a different IP.
>
> 2. Have a second set of perimeter devices (firewalls) programmed to use the
> IP's on the second connection, as a hot standby.
>
> My problem with the first option is the time it would take to reconfigure
> firewalls and IDS' to use the other ISP's connection. The problem I have
> with the second is the expense of firewalls and IDS' just sitting there
> idle. 
>
> Any input is greatly appreciated!
>
>
> Dan 
>
>
>
>
>