We run portfast on all Catalyst ports that connect to a "non-switch"
device, like PCs, servers, routers, etc. From what I saw, it works by
not listening for MAC addresses as long before going to "active" state.
I have never heard of any security issues by doing this. I believe Cisco
still recommends this mode for optimum performance. You can always use
Nessus (or some other up to date vuln scanner) to see if anything can be
exploited.
As for why it happens, here's my thought. Because it's speeding up a
"natural" switch port process, weird things can happen. Depending on how
the device (i.e. PC hardware) acts on layer 2, it may need the "full"
startup procedure to be run. To me, portfast is a non-standard shortcut,
and it may not work in every situation. As you probably read, you can't
plug a portfast port into a switch, so there could easily be other
devices it's incompatible with (Cisco can't test everything).
-----Original Message-----
From: Josh Sukol [mailto:secnews@gmail.com]
Sent: Friday, September 24, 2004 10:05 AM
To: security-basics@securityfocus.com
Subject: PortFast Question
I am running a small network using four Cisco Catalyst 2950 switches.
I am in the process of configuring a new software package that uses some
proprietary hardware that connects to the network via Ethernet.
When plugged into the network the device would connect for a minute or
two and than connectivity would drop (i.e. ping would fail, and the
light on the switch would turn from green to amber) This pattern
continued for as long as the device was plugged into the network. The
cabling was checked and tested with other equipment and there were no
other problems.
After trying several other things I eventually started changing the
ethernet port settings on the switch itself and found that by enabling
portfast the device functioned fine. I have found very little
information about port fast security issues. I was able to find and did
read up on PortFast BPDU guard and potential DoS using malformed
packets. Are there any other security issues that effect me enabling
Portfast on specific ports that connect back to a single device? Are
there any other ways to solve this problem that might allow me to
sidestep this potential security issues all together?
- Slightly Off Topic -
If anyone knows why this behavior occurs and why enabling portfast fixes
the connectivity issue I would be very interested to a hear an
explanation.
Thanks in advance for the wisdom!
------------------------------------------------------------------------
---
Computer Forensics Training at the InfoSec Institute. All of our class
sizes
are guaranteed to be 12 students or less to facilitate one-on-one
interaction with one of our expert instructors. Gain the in-demand
skills of
a certified computer examiner, learn to recover trace data left behind
by
fraud, theft, and cybercrime perpetrators. Discover the source of
computer
crime and abuse so that it never happens again.
http://www.infosecinstitute.com/courses/computer_forensics_training.html
------------------------------------------------------------------------
----
