Hi there,
The XSL Templates referenced below could be used with the Nessus 3.0.x
windows client. The reporting system in Windows 3.0.x Nessus used templates
to generate html reports.
These XSL templates are not used in the Nessus 3.2 client.
Ron Gula
Tenable Network Security
Crusade, Jennifer wrote:
Hello;
I need to generate reports for format reports by vulnerabilities I
downloaded NRF but that does not let you export the information out so I
found the following
Archive for the 'Nessus' Category
Nessus XSL Templates - fresh from the oven! <http://digihax.com/wp/?p=3>
Check 'em out - all yours, all free, in the links section.
These templates allow you to generate reports which show only holes, or
only warnings, or holes & warnings, by host, and by vulnerability. Much
better, in my opinion. If you can't find the link:
http://www.aznetworksecurity.com/nessus_xsl.zip
These should be copied into (and over) the report_styles folder in a
Windows install, and can be used on their own in Linux (afaik) as well.
Thanks to those that helped along the way. Please provide
suggestions/tweaks, and let me know if you have any problems.
I have seen, on a very very large (20MB+) xml file, an inability to
create the report. Odd, because it worked just fine if you select just
holes, or just warnings, or the entire thing - but "Holes & Warnings"
failed... go figure. If you have any ideas, holler.
I have a Linux and windows version running 3.2.1 and on the Windows
install I do not have a report_styles folder at all. I am not sure
where to place the templates and how to actually generate the reports
using these xsl templates. Can anyone point me to some steps please?
_______________________________________________
Nessus mailing list
Nessus@list.nessus.org
http://mail.nessus.org/mailman/listinfo/nessus
