RE: Compliance check not showing anything

Hi Rossen,

Few things I had like you to check.

- Check if port 139/445 is open on the target system i.e (Allow file and
printer sharing exception is enabled.) 
- Check if the credentials are correct.
- Lastly, try running compliance checks from the command line

for e.g 

/opt/nessus/bin/nasl -Xt TARGET_IP compliance_check.nbin.

You should see a error message related to your issue.

If remote registry is disabled, checks that require registry access will
fail.

Also, if you are Direct feed/SC3 customer please consider opening a ticket
with our 
help desk regarding this issue.

- Mehul 

> -----Original Message-----
> From: nessus-bounces@list.nessus.org 
> [mailto:nessus-bounces@list.nessus.org] On Behalf Of Rossen 
> S. Naydenov
> Sent: Tuesday, February 26, 2008 10:26 AM
> To: nessus@list.nessus.org
> Subject: Compliance check not showing anything
>
> Hi guys,
>
> I am having hard time scanning hardened windows 2003 servers 
> for compliance.
>  
> The result only shows :
> =====================
> Start Time, Finish Time, and IP address
>  
> No Vulnerability Found
> =====================
>
> I have included the local checks failed plugin(#21745), but 
> nothing is shown. I have double checked that the audit file 
> is there and is ok. On the servers the remote registry is 
> disabled. Could this be the problem?
>
> Thanks.
>
> _______________________________________________
> Nessus mailing list
> Nessus@list.nessus.org
> http://mail.nessus.org/mailman/listinfo/nessus

_______________________________________________
Nessus mailing list
Nessus@list.nessus.org
http://mail.nessus.org/mailman/listinfo/nessus