I am running a firewall on HP DL380 and attached to a Proventia G400 and
I am having trouble getting the nic's to run at 100/FD. When I hard
code them on the Proventia, firewall and switch it causes the nic on the
firewall to go to "no link". When I set it to Auto neg on the firewall
and Proventia it goes to 100/HD. I can not seem to make this work
running a 100/FD. I have had the network person set the speed on the
switch to Auto neg and when I hard code everything to 100/FD it shows up
on the switch as 100/HD.
I) I have swapped cables out (both the cross over and straight cable
connection)
2) Changed nics from integrated to Intel Pro/1000 Dual Port
3) changed ports on switch
4) went directly from the firewall to the switch (bypassing Proventia)
and can run at 100/FD.
5) RMA'd the Proventia box - same problem
Spoke with Checkpoint they say its not a problem on the firewall since
it can run at 100/FD when connected directly to the switch.
ISS so far has no suggestions and has not responded with any suggestions
on how to correct this.
I was hoping someone else might be running with a Proventia and firewall
and could tell me how they made it work while running at 100/FD.
Thanks,
Annette
_______________________________________________
ISSForum mailing list
ISSForum@atla-mm1.iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security Systems,
6303 Barfield Road, Atlanta, Georgia, USA 30328.
