There's a tool which you can find in the knowlegde base to help you
change the IP Address of your SP but it seems it use when you have all
components in the same server. I do not know if you can use it in a
custom (recommended) installation.
About the sensors, I think the way is to unregister the sensor an
register them again.
May be you have to unregister the sensor, change the ip address of SP
compoments and finally register the sensors again.
-----Original Message-----
From: issforum-bounces@iss.net [mailto:issforum-bounces@iss.net] On
Behalf Of Plamen.Martinov@walgreens.com
Sent: Tuesday, May 02, 2006 9:36 AM
To: issforum@iss.net
Subject: [ISSForum] Changing IP address -> Has anyone done it?
I am in the process of changing Siteprotector Core, Siteprotector
Database, Event Collector and all sensors to a new IP address range. I
was
wondering if anyone has gone through a similar process and can provide
me
with some useful information, especially getting the database,
application
and event collecter to communicated after the ip are changed. Do I have
to
uninstall and re-install everything?
Thank you,
Plamen Martinov
Walgreens
IT - Systems Security
(847) 914 - 5425 _______________________________________________
ISSForum mailing list
ISSForum@iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security
Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
_______________________________________________
ISSForum mailing list
ISSForum@iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security Systems,
6303 Barfield Road, Atlanta, Georgia, USA 30328.
