The Proventia G fully supports 802.1q traffic. No special configuration
is necessary in most cases. However, if you are using the Proventia G in
passive mode and feeding kill packets back into your network via a kill
port, you may need to tune the sensor somewhat to produce kill packets
that are compatible with your network equipment and the point at which
you feed those packets back into your network.
-----Original Message-----
From: issforum-bounces@atla-mm1.iss.net On Behalf Of Hernandez, Marco
Sent: Wednesday, April 12, 2006 1:08 PM
To: issforum@atla-mm1.iss.net
Subject: [ISSForum] 802.1q Support
Hi All,
Do you know if Proventia G support 802.1q standard?
I mean, if I connect the G to a trunk port, does it will capable to
decapsulate the VLAN tagging, analyze the packet, and encapsulate it
again? Do I have to configure something special to the Proventia?
Thanks a lot
_______________________________________________
ISSForum mailing list
ISSForum@iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security
Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
_______________________________________________
ISSForum mailing list
ISSForum@iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security Systems,
6303 Barfield Road, Atlanta, Georgia, USA 30328.
