Upgrading to Firmware 1.2 I take it? I'm assuming that you're using the ISS
disk which contains the updated firmware. This disk is bootable so you'll
need to make sure that your boot order is correct in the G's BIOS. When you
power up the machine go into the setup (F2) and arrow over to the Boot
section. Make sure that the CDROM is the 1st boot device. Then try to boot
from the disk. The disk should bring you to a shell prompt where you'll
type reinstall. A couple of minutes later you'll reboot again and go
through the configuration via terminal emulation. The HTTD will start and
you'll be able to manage the appliance from your browser.
Good luck,
Chad
-----Original Message-----
From: issforum-bounces@iss.net [mailto:issforum-bounces@iss.net] On Behalf
Of Neil Kemp
Sent: Wednesday, January 25, 2006 6:16 AM
To: ISSForum@iss.net
Subject: [ISSForum] Upgrading G200 Appliance
Hi there, I have a CD which contains the latest software for the G200
appliance. This software contains the local management through the GUI,
which the older version that is currently installed doesnt.
I have put the CD in the drive, but how do I upgrade it ?
Tried logging on as root, and typing reinstall etc.
Any ideas ?
Thanks in advance
_______________________________________________
ISSForum mailing list
ISSForum@iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security
Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
_______________________________________________
ISSForum mailing list
ISSForum@iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to mod-issforum@iss.net
The ISSForum mailing list is hosted and managed by Internet Security Systems,
6303 Barfield Road, Atlanta, Georgia, USA 30328.
