[ISSForum] Failed to open control channel to the sensor

Hi All,

 

This is the description of the problem;

 

Using SiteProtector 2.0 (SP5.2), ServerSensor agents installed on Solaris 8.0 
servers.

 

The status for all servers is Active, I can register/unregister the agents on 
the SP console.

I can also assign a different EC to the agents and Events are showing up. The 
Last Contact

under the Sensor Tab is only a couple of minutes old at most.

 

I cannot perform any actions (Stop-Start-Apply XPU-Apply Policy,...) on the 
server sensors.

The error message is always the same; Failed to open control channel to the 
sensor, cannot

perform any actions on it. I doubled the timeout to open the control channel, 
but that did not help.

 

Anyone run into this before?

 

Thank you,

 

Jean Levert

 

Bell Corporate Security - IDS- Sonar

Sûreté de l'entreprise Bell - IDS - Sonar

 

_______________________________________________
ISSForum mailing list
ISSForum@iss.net

TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to 
https://atla-mm1.iss.net/mailman/listinfo/issforum

To contact the ISSForum Moderator, send email to mod-issforum@iss.net

The ISSForum mailing list is hosted and managed by Internet Security Systems, 
6303 Barfield Road, Atlanta, Georgia, USA 30328.