[ISSForum] Applying Response

Dear all,

Recently i have installed a ISS SiteProtector and i have problem in applying a 
customised response.   I created a new network response using the derive new 
button and after configuring the new response when i try to apply the response 
to a sensor, i get a message saying that the response is successfully applied 
and the status of the sensor goes to stop mode and then when i try to start the 
sensor i get a failed message and the error message i get is "Sensor failed to 
initialize and exited.  Please check the event log on the sensor machine" but i 
don't see any error message in sensor machine.  Please let me know what is the 
solution for this problem.     I am able to successfully apply the built-in 
network response to the sensor without any errors.

Regards,

G G Venkat Raman

"Excellence is not a destination; it is a continuous journey that never ends."



_______________________________________________
ISSForum mailing list
ISSForum@iss.net

TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to 
https://atla-mm1.iss.net/mailman/listinfo/issforum

To contact the ISSForum Moderator, send email to mod-issforum@iss.net

The ISSForum mailing list is hosted and managed by Internet Security Systems, 
6303 Barfield Road, Atlanta, Georgia, USA 30328.