Re: E450 - hangs when booting without keyboard and monitor

In the PROM set input and output device to ttya and (if needed which it won't 
be 
with the laptop connected) pull the control lines the correct way with 
resistors.  Make sure the laptop mimics a vt100 at the same settings as are in 
the PROM.  Better get a genuine vt100 and connect that, you can disconnect it 
once booted.  Our E450 runs into a multipole switch that selects which one of 
many computers the single vt100 (god bless DEC) displays.

John

John Landamore

School of Mathematics & Computer Science
University of Leicester
University Road, LEICESTER, LE1 7RH
J.Landamore@mcs.le.ac.uk
Phone: +44 (0)116 2523410       Fax: +44 (0)116 2523604


> I have an E450 and I would like to remove the keyboard and monitor.  I
> powered the server down, and then removed the keyboard and monitor.  When I
> power the server back on it hangs during the boot process.  If I power off
> and reattach the monitor and keyboard it then boots fine.  I did not do a
> lot of troubleshooting because I did not want the machine offline for a long
> time, but was hoping someone might have a few tips before I try again.
>
> I did have a console connection via my laptop to the serial port when
> booting without the keyboard and monitor and did not see any errors.  It
> would finish the memory initialization then start the boot process and just
> hang shortly after that.
>
> Regards,
> Jason