I know that I have set up a basic open standard IPSEC VPN between a Netopia
router and a Juniper Netscreen 50 with no problems.
Chris Serafin
IT Security / Voice Engineer
chris@chrisserafin.com
-----Original Message-----
From: bill.louis@gmail.com [mailto:bill.louis@gmail.com] On Behalf Of Louis
Wang
Sent: Friday, December 30, 2005 10:33 PM
To: Brodsky, Jared S.
Cc: firewalls@securityfocus.com
Subject: Re: IPSec VPN Between Fortigate-100 and Netopia 3000
hi,
I don't know Netopia router but I am very good experienced with
FortiGate configuration. A success negotiation would have 5 messages
OK, I only see 3 here and no failure notice about the other 2
negotiate message.
Are you sure your VPN setting is right? If not, please give me
more info, maybe i could help you.
On 10/21/05, Brodsky, Jared S. <JaredB@greatertalent.com> wrote:
Hello all,
I am in the process of setting up a point to point VPN between our NY
office and our Office in Florida. The NYC office has a T1 and our Fla.
Office is equipped w. ADSL. I am trying to set up a VPN tunnel between the
two locations using a Fortigate 100 and a Netopia 3000 router. Looking at
the logs on my Fortigate I have the following messages
12 2005-10-20 13:20:46 notice negotiate Initiator: sent 70.148.141.142
quick mode message #1 (OK)
13 2005-10-20 13:20:46 notice negotiate Initiator: parsed 70.148.141.142
main mode message #3 (DONE)
14 2005-10-20 13:20:45 notice negotiate Responder: sent 70.148.141.142
main mode message #3 (OK)
15 2005-10-20 13:20:45 notice negotiate Initiator: sent 70.148.141.142
main mode message #2 (OK)
16 2005-10-20 13:20:44 notice negotiate Initiator: sent 70.148.141.142
main mode message #1 (OK)
However, for some reason the tunnel never goes up. I believe it may have
to do w/ something on the Netopia IPsec configurations and its policy but I
cannot figure this out.
Any help would be greatly appreciated!
Thanks,
Jared
--
Regards,
Louis Wang
