I've seen this before...
Make sure all ur interfaces are set to the right speed and duplexity, 100 full
duplex including switches and routers..
Also check buffers on the pix may have to increase. Them a litle.
--------------------------
Sent from my BlackBerry Wireless Handheld
----- Original Message -----
From: "NAVTEJ KOHLI" [tonavtejkohli@hotmail.com]
Sent: 21/11/2005 01:30 PM
To: firewalls@securityfocus.com
Subject: Pix Firewall Issue
Hello Lists,
I am using Cisco pix 525. I have got problem with PIX firewall 525,
Interfaces ( inside, outside)
continuously "up-down" when I use with large traffic ( about 10Mb), but It
works fine when traffic less then 10 mb. Is any one has anyidea.
Any Suggestion are most welcome !!!
Regards,
NAVTEJ KOHLI
_________________________________________________________________
Don't just search. Find. Check out the new MSN Search!
http://search.msn.click-url.com/go/onm00200636ave/direct/01/
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
"NOTICE
This email and any attachments are confidential and are intended only for the use of the
named recipient. They may contain legally privileged information and are subject to
copyright. You must not read, copy, use or disclose them without our prior written
consent. If you have received this email in error please notify us on +61 (0)3 9209 2000 or
by return email and then delete both messages.
We do not warrant that this email or any attachments are error or virus free or that this
communication is secure and accept no liability for computer viruses, data corruption,
delay, interruption, unauthorised access or unauthorised amendment."
