Hi List,
I have installed two modules of firewall NGR55+HF13 over Solaris 9 and my
SmartCenter is running over SecurePlatform NG R55+HF13, The status of the
Cluster is : (Active- OK /Stanbye-OK) and we have tested the high
availibility.This works very well.The stateful failover is very good. But,
there is a problem...(I dont know if it is a real problem), in our
SmartCenter- SmartView Log shows the following messages :
#######################################################################################
cluster_info :(ClusterXL) member 2 (172.20.0.2) is up
cluster_info :(ClusterXL) member 2 (172.20.0.2) is stanby
cluster_info :(ClusterXL) interface bge0 of member 2 (172.20.0.2) is up
cluster_info :(ClusterXL) member 2 (172.20.0.2) is down (Interface Active
Check on member 2 (172.20.0.2) detecteda a problem ( 4 interfaces
required,only 3 up).
cluster_info : (ClusterXL) interface bge0 of member 2 (172.20.0.2) is down
(receive up,transmit down)
cluster_info : (CLusterXL) member 2 (172.20.0.2) is up (Interface Active
Check on member 2 (172.20.0.2) status OK.).
cluster_info : (ClusterXL) member 2 (172.20.0.2) is up
cluster_info : (ClusterXL) member 2 (172.20.0.2) is standby
cluster_info :(ClusterXL) interface bge0 of member 2 (172.20.0.2) is up
cluster_info :(ClusterXL) member 2 (172.20.0.2) is down
#######################################################################################
We have performed the following actions :
1.- set_ccp traffic Multicast to Broadcast in each module of firewall
(Done)
when we execure this command it shows us randomize messages.
2.- Disable IGMP in the Switch 6500 (Done)
3.- Disable( Spanning Tree in The Switch 6500 (Done)
But, The messages are still showing.
I will appreciate your help.
Cesar Farro.
