Do inform me on the firmware version. mine is released 1 Dec 2004 and there
is a scheduled release in Jan 2005 according to hotbrick. perhaps you have
one more firmware to update.
_____
From: Eric McCarty [mailto:eric@piteduncan.com]
Sent: 22 December 2004 16:09
To: Support@ttmetals.com; firewalls@securityfocus.com
Subject: RE: HOTBrick LB2vpn update 2
Agreed, once the firmware is upgraded, every time u have to re-change back
the settings. Now mysteriously my WAN2 is dead, no link light, nothing,
either the port is dead or the unit does not like me now, either way it
sucks.
_____
From: Chili G. [mailto:Support@ttmetals.com]
Sent: Tuesday, December 21, 2004 4:39 PM
To: firewalls@securityfocus.com
Subject: FW: HOTBrick LB2vpn update 2
One more update as regards to the firewall.. I saved the current config but
when put that back on a reset firewall.. it did not pickup the settings
(the previous config). I bet the best way round this sit to put all routes
again . . .
_____
From: Chili G. [mailto:Support@ttmetals.com]
Sent: 22 December 2004 00:38
To: 'firewalls@securityfocus.com'
Subject: HOTBrick LB2vpn update
Hello All,
The box works fine but I had the following problems:
1. As a DHCP server, it sometimes does not issue IP's always.. so not
good to use the box as a DHCP server.
2. The LB2-VPN firmware has to be updated. This can be down through the
web browser and not necessarily use a tftp software as someone mentioned.
The entire network was NOT stable until after the firmware was updated. This
could have cost me quite a bit on network downtime
I am putting in another DSL to see load balancing issues or failovers. will
update soon. however, so far, the box works great, apart from the above
problems
Chili
IT Support
