sounds strange - are you sending snmp-traps from the PIX? does that give
you any info?
Spigga <spigga@gmail.com> 15/11/2004 9:47:09 am >>>
Thats the odd part, these pairs were failing fine in the past, we test
often, and we have about 250 more pairs that are fine. Since I sent
this email one pair has decided to play nice, no config changes. We
brought the primary up to do some troubleshooting and the problem was
gone. One pair is still having the same issue. We're going to spend
some time with the failed pair on Monday. I guess we'll see what
happens.
On Mon, 15 Nov 2004 09:35:19 +1000, Ivan Coric
<ivan.coric@workcoverqld.com.au> wrote:
verify your failover config -
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_v50/config/advanced.htm
use the command show failover - this will show you the status of the
failover
cheers
Ivan
Ivan Coric, CISSP, RHCE
IT Technical Security Officer
Information Technology
WorkCover Queensland
Ph: (07) 30066414 Fax: (07) 30066424
Email: ivan.coric@workcoverqld.com.au
Spigga <spigga@gmail.com> 12/11/2004 8:56:21 am >>>
I have 2 HA pairs that refuse to failover properly. If the primary
is
active, and I try to fail it over to standby, they both go standby
and
traffic halts. I have to power cycle the primary and all is well.
This is the same situation on two separate pairs one pair running
6.3(3) and one running 6.3(4). They both started doing this on the
same day. One during failover testing and one pair just stopped
passing traffic and never failed over so we had a guy power off the
primary and since then failover does not work. In one case we
replaced the primary and it still happens. We have replaced serial
and lan failover cables. Anyone seen or heard of this? We have
close
to 300 pixes, a large number runninf 6.3(3) and some running 6.3(4)
and no others are having trouble but we haven't failed any over
since
this started. I'm afraid to test.
***************************************************************************
Messages included in this e-mail and any of its attachments are
those
of the author unless specifically stated to represent WorkCover
Queensland. The contents of this message are to be used for the intended
purpose only and are to be kept confidential at all times.
This message may contain privileged information directed only to the
intended addressee/s. Accidental receipt of this information should be
deleted promptly and the sender notified.
This e-mail has been scanned by Sophos for known viruses.
However, no warranty nor liability is implied in this respect.
**********************************************************************
***************************************************************************
Messages included in this e-mail and any of its attachments are those
of the author unless specifically stated to represent WorkCover Queensland. The
contents of this message are to be used for the intended purpose only and are
to be kept confidential at all times.
This message may contain privileged information directed only to the intended
addressee/s. Accidental receipt of this information should be deleted promptly
and the sender notified.
This e-mail has been scanned by Sophos for known viruses.
However, no warranty nor liability is implied in this respect.
**********************************************************************
