I believe that the PIX does not allow for two default gateways.
I have heard of others implementing a similar solution by getting a second
pix, hooking it up to the same switch, and putting an additional default
gateway on the switch.
This can result in assymetrical routing (out one pix and back in the
other), but I haven't heard of any complaints as a result of it--no one
doing this was hosting anything on the Internet via either connection. It
was just an outbound solution. I suppose if you wanted to get fancy you
can route map that this VLAN goes out this gateway, or do a QoS where 50%
of the traffic goes out 50% of either gateway, and then vice versa, if you
did not trust the switch's (I am assuming layer 3 switch) round-robin
default gateway packet provisioning.
And one of my friends that has an elaborate setup at home did this with a
cable modem and a DSL connection to meet his speed needs!
"francisco_gala@inicia.es" <francisco_gala@inicia.es>
08/13/2004 03:07 AM
Please respond to
francisco_gala@inicia.es
To
firewalls@securityfocus.com
cc
Subject
Pix can manage two routers with ADSL
Hi everybody,
I have a firewall PIX 525 with five interface. Nowadays Pix allow traffic
from Internet by the outside interface. But I want to configure another
interface with conection to Internet with another ADSL router. So, Is it
possible to use another interface in ordet to connect to Internet?. And
how
can I configure my PIX if it is possible the solution?
Thank you,
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
